Print Page | Close Window

Configuration Management

Printed From: Epicor Discussion Forums
Category: Epicor University
Forum Name: Epicor ERP Manufacturing and Supply Chain Management
Forum Description: Epicor ERP Manufacturing and Supply Chain Management
Printed Date: 12 December 2018 at 20:20
Software Version: Web Wiz Forums 12.01 -

Topic: Configuration Management
Posted By: MickeyD
Subject: Configuration Management
Date Posted: 23 April 2014 at 14:31
At our company, we are looking for a way to control multiple configurations for assemblies that could run in parallel.
i.e. We have 2 assemblies with the same part number, Rev A for Lot 1, and Rev B for Lot 2. It looks like we can control the release of those by the effectivity date, but we would like to have a unique identifier that shows up on all the various reports as well as shop orders so it is obvious to anyone looking at it which part goes to which Lot or final assembly.
Anyone know if there is a way to do that in E9?


Posted By: TShoemaker
Date Posted: 05 August 2015 at 06:59
I believe that the revision letter prints on the shop traveler. I do know that the revision letter is part of the job. 
The problem is that Epicor does not track revisions of parts once they arrive in stock. If your are lot controlled (which it looks like) then the lot number would help in tracking that back to the job, which points to the revision. If not lot controlled, once the part is put into inventory, then the inventory is mixed with all parts that are in stock, and revision tracking is lost. 

There has been discussions that sometime in the future, Epicor may support revision tracking in inventory, but it is not yet.

Tim Shoemaker
Principal Consultant - Professional Services
Epicor Software Corporation

Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.01 -
Copyright ©2001-2018 Web Wiz Ltd. -